|
4-2-4-snyatie-i-ustanovka-kolesa.html
4.2.4. Removal and installation of a wheelRemoval
|
|
Fig. 4.13. Otvorachivaniye of nuts of fastening of a wheel
|
Turn off nuts of fastening of wheels approximately on 180 ° (half-turn) (fig. 4.13). Lift the car on the elevator.
Remove a wheel.
|
ATTENTION
Never heat a wheel for simplification of its removal because high temperature can reduce service life of a disk and bearings of a wheel.
|
Installation
Installation is made as it should be, the return to removal, except for the following.
Nuts of fastening of a wheel has to be are tightened in a certain sequence and the corresponding moment of an inhaling to prevent deformation of a disk of a wheel or brake disk.
|
|
Fig. 4.14. Sequence of an inhaling of nuts of fastening of a wheel
|
|
NOTE
Before installation of wheels, remove a rust from a landing surface of a disk of a wheel and a landing surface of a brake disk with a scraper and a wire brush. Installation of disks in the absence of good contact of landing surfaces can lead to weakening of an inhaling of a nut of a disk with the subsequent office of a wheel at the movement of the car (fig. 4.14).
|
Moment of an inhaling of a nut of wheels (a): 85 N · m.
|