Suzuki Liana since 2002
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
7.1. System of lighting
7.2. Equipment of salon
7.3. Screen wipers and windscreen washers
7.3.1. Removal and installation of a tank and pump of windscreen washer
7.3.2. Check of the electric motor of a screen wiper
7.3.3. Check of the electric motor of a cleaner of back glass (if is available)
7.3.4. Removal and installation of the switch of a cleaner and washer of a windshield
7.3.5. Removal and installation of the relay of faltering work of a back screen wiper
7.4. Electric checks of components of a control system of the engine
8. Body
9. Schemes of electric equipment
 






7-3-4-snyatie-i-ustanovka-pereklyuchatelya-ochistitelya-i-omyvatelya-vetrovogo-stekla.html

7.3.4. Removal and installation of the switch of a cleaner and washer of a windshield

Removal
Disconnect a wire from a negative conclusion of the rechargeable battery.
Remove a cap of a steering column 1.
Uncover a steering column 2.

Fig. 7.7. Removal of covers of a steering column


Then turn a steering wheel to unscrew back screws of covers of a steering column (fig. 7.7).

Fig. 7.50. Removal of the switch of a cleaner and washer of a windshield


Remove the switch of a cleaner and washer of a windshield 1 from the combined switch 2 and to disconnect its socket 3 (fig. 7.50).

Installation
Installation is made as it should be, the return to removal.

Check of the switch of a cleaner and washer of a windshield

Fig. 7.51. Scheme of check of the switch of a cleaner and washer of a windshield


Switch of a cleaner and washer of a windshield (fig. 7.51).
Check integrity of a chain between conclusions at each position of the switch. If result of check negative, replace the switch.

Check of faltering work of a screen wiper

Fig. 7.52. Scheme of check of faltering work of a screen wiper


Install the switch of screenwash in the provision of "INT" (fig. 7.52).
Connect a positive conclusion of the rechargeable battery to a conclusion of "B3", and a negative conclusion to a conclusion of "EW".
Connect a positive wire of the voltmeter to a conclusion of "L", and a negative wire to a conclusion of "EW".
The voltmeter has to show tension of the rechargeable battery (10–14 V).
Connect conclusions of "AS" and "B3" to 5 pages or more crossing point.
Disconnect a crossing point from a conclusion of "B3".
Connect the disconnected end of a crossing point to a conclusion of "EW", then make sure that tension between conclusions of "L" and "EW" changes as it is specified.
If result of check not satisfactory, replace the switch.

Check of a washer

Fig. 7.53. Scheme of check of work of a washer


Make sure that the switch of a forward screen wiper is in situation "Is switched off" (fig. 7.53).
Connect a positive conclusion of the rechargeable battery to a conclusion of "B3", and a negative conclusion to a conclusion of "EW".
Connect a positive wire of the voltmeter to a conclusion of "L", and a negative wire to a conclusion of "EW".
When the switch of a forward washer is in situation "Is included", check tension izameneniye, as shown in the drawing.
If result of check not satisfactory, replace the switch.

Check of the switch of a cleaner and washer of back glass

Fig. 7.54. Scheme of check of operation of the switch of a cleaner and washer of back glass


Check integrity of a chain between conclusions at each position of the switch. If result of check negative, replace the switch (fig. 7.54).

"previous page
7.3.3. Check of the electric motor of a cleaner of back glass (if is available)
following page"
7.3.5. Removal and installation of the relay of faltering work of a back screen wiper