Suzuki Liana since 2002
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
7.1. System of lighting
7.2. Equipment of salon
7.2.1. Removal and installation of the switch of ignition
7.2.2. Removal and installation of a combination of devices
7.2.3. Check of the switch of a control lamp of the parking brake system
7.2.4. Check of the trailer switch of a door (forward / back door)
7.2.5. Check of the trailer switch of a door of a back (for models with a body the versatile person)
7.2.6. Check of the switch of a trunk lid
7.2.7. Removal and installation of a combination of devices
7.2.8. Removal and installation of the information display or hours
7.2.9. Removal and installation of the radio receiver
7.2.10. Removal and installation of the forward loudspeaker
7.2.11. Removal and installation of the back loudspeaker (for models with a body the sedan)
7.2.12. Removal and installation of the back loudspeaker (for models with a body the versatile person)
7.2.13. Removal and installation of the antenna amplifier (for models with a body the sedan)
7.2.14. Removal and installation of the antenna (for models with a body the versatile person)
7.2.15. Check of the remote control audio system
7.3. Screen wipers and windscreen washers
7.4. Electric checks of components of a control system of the engine
8. Body
9. Schemes of electric equipment
 










7-2-1-snyatie-i-ustanovka-vyklyuchatelya-zazhiganiya.html

7.2.1. Removal and installation of the switch of ignition

Removal
Disconnect a wire from a negative conclusion of the rechargeable battery.
Make sure that the key is not inserted into the ignition lock.
Remove a cap of a steering column 1.

Fig. 7.7. Removal of covers of a steering column


Uncover a steering column 2. Then turn a steering wheel to unscrew screws of 3 covers of a steering column (fig. 7.7.).

Fig. 7.23. Removal of the switch of ignition


Disconnect sockets from the switch of ignition of 1 (fig. 7.23).
Remove the switch of ignition 1 from the cylinder of the lock 2 (fig. 7.23).

Installation
Installation is made as it should be, the return to removal.

Check of the switch of ignition

Fig. 7.24. Scheme of check of the switch of ignition


Check integrity of a chain between conclusions at each position of the switch (fig. 7.24). If result of check negative, replace the switch.

"previous page
7.2. Equipment of salon
following page"
7.2.2. Removal and installation of a combination of devices