Suzuki Liana since 2002
1. Operation and maintenance of the car
2. Engine
2.1. Preliminary checks
2.2. Mechanical part of engines
2.3. Engine cooling system
2.4. Engine lubrication system
2.5. Fuel system
2.6. System of ignition
2.7. System of release
2.7.1. Description of system of release
2.7.2. Removal and installation of a final collector
2.7.3. Removal and installation of an exhaust pipe
2.8. The engine and system of decrease in toxicity of the fulfilled gases (M13 and M16 engines)
2.9. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 






2-7-1-opisanie-sistemy-vypuska.html

2.7.1. Description of system of release

Fig. 2.264. Details of system of release: 1 – a cover of a final collector (with the sensor of concentration of oxygen); 2 – laying; 3 – a final collector (with the sensor of concentration of oxygen); 4 – the oxygen sensor with heating No. 1; 5 – sealing ring; 6 – exhaust pipe No. 1; 7 – exhaust pipe No. 2; 8 – muffler; 9 – fastening of the muffler; 10 – laying; 11 – a cover of a final collector (without sensor of concentration of oxygen); 12 – a final collector (without sensor of concentration of oxygen); 13 – the oxygen sensor with heating No. 2 (if is available); 14 – converter case; 15 – exhaust camera; 16 – amplifier of a final collector; 17 – nut of an exhaust pipe: tighten at first a nut of an exhaust pipe (a), and then (b), as shown in a type of "A"; 18 – top party



The system of release consists of a final collector, three-component catalytic converter in the case, exhaust pipes, the muffler and consolidations, laying and, etc.
Three-component catalytic converter represents the device for decrease in toxicity of exhaust gases which is built in system of release that decrease in concentration of hydrocarbons (CH), carbon monoxide (SO) and oxides of nitrogen (nox) in the fulfilled gases.

Instructions on repair

ATTENTION
To avoid risk of receiving burns, do not touch system of release until it cooled down. Any service of system of release has to be carried out only after the system cools down.

"previous page
2.7. System of release
following page"
2.7.2. Removal and installation of a final collector