|
2-3-12-proverka-i-regulirovka-natyazheniya-privodnogo-remnya-nasosa-okhlazhdayushhejj.html
2.3.12. Check and adjustment of a tension of a driving belt of the pump of cooling liquid / generator
|
ATTENTION
Before check and adjustment of a tension of a belt disconnect a wire from a negative conclusion of the rechargeable battery.
Not to get burns, do not remove a radiator stopper if the engine and a radiator did not cool down yet. If the engine cooled down not enough, then at removal of a stopper of a radiator there can be an emission of hot liquid and steam.
|
Check a belt for existence of cracks, cuts, deformations, wear and pollution. If it is necessary to replace a belt.
Check a belt tension. The belt is tense normally if it has a deflection from 4,5 to 5,5 mm under pressure of a hand thumb (about 100 N).
Tension of a driving belt of the pump cooling the liquid / generator: a deflection of 4,5-5,5 mm at effort of 100 N (fig. 2.197).
|
NOTE
When replacing a belt with new, adjust a belt tension so that the deflection made 3–4 mm.
|
|
|
Fig. 2.198. Adjustment of a tension of a driving belt
|
If the belt is tense too strongly or too poorly, adjust a tension movement of the generator (fig. 2.198). Tighten an adjusting bolt of the generator and bolts of hinges nominal force.
Connect a negative wire in the rechargeable battery.
Inhaling moment
Adjusting bolt of the generator (a): 23 N · m.
Bolt of the hinge of the generator (b): 50 N · m.
|