Suzuki Liana since 2002
1. Operation and maintenance of the car
2. Engine
2.1. Preliminary checks
2.2. Mechanical part of engines
2.3. Engine cooling system
2.3.1. General information
2.3.2. Diagnostic information and procedures
2.3.3. Removal and installation of tubes or hoses of the cooling system
2.3.4. Removal and installation of the thermostat
2.3.5. Check of the thermostat
2.3.6. Removal and installation of the valve in a throttle branch pipe (if is available)
2.3.7. Check on the cooling system radiator fan car
2.3.8. Check of the relay of the fan of the cooling system
2.3.9. Removal and installation of the fan of the cooling system
2.3.10. Check and cleaning of a radiator on the car
2.3.11. Removal and installation of a radiator
2.3.12. Check and adjustment of a tension of a driving belt of the pump of cooling liquid / generator
2.3.13. Removal and installation of a driving belt of the pump of cooling liquid / generator
2.3.14. Removal and installation of the pump of cooling liquid
2.3.15. Check of the pump of cooling liquid
2.4. Engine lubrication system
2.5. Fuel system
2.6. System of ignition
2.7. System of release
2.8. The engine and system of decrease in toxicity of the fulfilled gases (M13 and M16 engines)
2.9. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 






2-3-13-snyatie-i-ustanovka-privodnogo-remnya-nasosa-okhlazhdayushhejj-zhidkosti-generatora.html

2.3.13. Removal and installation of a driving belt of the pump of cooling liquid / generator

Removal
Disconnect a wire from a negative conclusion of the rechargeable battery.
Remove the lower cover of the engine on the right side and a generator cover (if is available).

Fig. 2.199. Adjusting bolt of a driving belt and bolt of the hinge of the generator


Weaken an adjusting bolt of a driving belt 2 and a bolt of the hinge of the generator 3 (fig. 2.199).
At service of the car equipped with the air conditioning system before removal of a belt of the pump of cooling liquid 1 remove a driving compressor belt.
Weaken a belt movement of the generator and remove it.

Installation

Fig. 2.200. Installation of a driving belt


Establish a belt 1 on a pulley of the pump of cooling liquid 2, a pulley of a bent shaft 3 and a pulley of the generator 4 (fig. 2.200).
At service of the car equipped with the air conditioning system also establish a driving compressor belt.
Adjust a belt tension.
For adjustment of a tension of a driving compressor belt.
Tighten an adjusting bolt of a belt of the drive of the pump of cooling liquid and a bolt of the hinge the nominal force of an inhaling.

Inhaling moment
Adjusting bolt of the generator (a): 23 N · m.
Bolt of the hinge of the generator (b): 50 N · m.
Establish the lower cover of the engine on the right side and a generator cover (if is available).
Connect a wire to a negative conclusion to the rechargeable battery.

"previous page
2.3.12. Check and adjustment of a tension of a driving belt of the pump of cooling liquid / generator
following page"
2.3.14. Removal and installation of the pump of cooling liquid