|
2-8-10-proverka-datchika-polozheniya-kolenchatogo-vala.html
2.8.10. Check of the sensor of provision of a bent shaftCheck the sensor of provision of a bent shaft, according to the diagnostic table P0335 (No. 23). If the sensor is faulty, replace it.
Removal
Disconnect a wire from a negative conclusion of the rechargeable battery.
Take off a driving belt of the generator, weaken a bolt of the hinge and displace the generator outside.
Disconnect the socket from the sensor of provision of a bent shaft.
|
|
Fig. 2.286. Location of the sensor of provision of a bent shaft
|
Remove the sensor of provision of a bent shaft 1 from the block of cylinders (fig. 2.286).
Installation
|
|
Fig. 2.287. Installation of the sensor of provision of a bent shaft
|
Make sure that the sensor of provision of a bent shaft and the cogged pulley have no damages and on them there are no metal particles (fig. 2.287). Install the sensor of provision of a bent shaft on the block of cylinders.
Connect the socket to the sensor.
Adjust a tension of a driving belt of the generator.
Connect a wire to a negative conclusion of the rechargeable battery.
|