Suzuki Liana since 2002
1. Operation and maintenance of the car
2. Engine
2.1. Preliminary checks
2.2. Mechanical part of engines
2.3. Engine cooling system
2.4. Engine lubrication system
2.5. Fuel system
2.6. System of ignition
2.7. System of release
2.8. The engine and system of decrease in toxicity of the fulfilled gases (M13 and M16 engines)
2.8.1. Electronic control system
2.8.2. Service on the car
2.8.3. Control unit of the engine of an electronic control system (electronic control unit)
2.8.4. The sensor of absolute pressure in a collector
2.8.5. Sensor of provision of a butterfly valve
2.8.6. The air temperature sensor on an admission
2.8.7. Sensor of temperature of cooling liquid of the engine
2.8.8. The sensor of concentration of oxygen with heating (the sensor of concentration of oxygen with heating No. 1 and the sensor of concentration of oxygen with heating No. 2)
2.8.9. Check of the sensor of provision of a cam-shaft
2.8.10. Check of the sensor of provision of a bent shaft
2.8.11. Main relay, relay of the fuel pump, relay of the compressor of the air conditioning system and relay of the fan of the condenser of the air conditioning system
2.8.12. Check of a control system of the fan of a radiator
2.8.13. Check of the filter of system of catching of vapors of gasoline of system of decrease in toxicity of the fulfilled gases
2.8.14. Check of the filter of system of catching of vapors of gasoline
2.8.15. System of ventilation of a case
2.9. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 










2-8-15-sistema-ventilyacii-kartera.html

2.8.15. System of ventilation of a case

NOTE
Before check of an operating mode of the regulator of idling check passability of the valve of ventilation of a case and its hoses, the contamination of the valve of ventilation of a case or its hose interferes with exact adjustment of the regulator of idling.

Check of a hose of the valve of ventilation of a case
Check hoses and their connections for existence of leaks, a contamination and damages. Replace if necessary.

Valve check of ventilation of a case

Fig. 2.295. Installation of a cap on the valve of ventilation of a case


Disconnect the valve of ventilation of a case 1 from a cover of a head of the block of cylinders and close an opening in a cover a cap (fig. 2.295).
Start the engine and leave it to idle.
Close the end of the valve of ventilation of a case 1 finger and check availability of vacuum (fig. 2.295).
If vacuum is not felt, check the valve regarding a contamination. Replace if necessary.
After vacuum check, stop the engine and remove the valve of ventilation of a case

Fig. 2.296. Check of mobility of a needle


Stir up the valve listening to a sound which is made at the same time by a valve needle. If there is no sound testifying to mobility of a needle, replace the valve (fig. 2.296).
After check remove a cap and install into place the valve of ventilation of a case 1.

"previous page
2.8.14. Check of the filter of system of catching of vapors of gasoline
following page"
2.9. Tables