Suzuki Liana since 2002
1. Operation and maintenance of the car
2. Engine
2.1. Preliminary checks
2.2. Mechanical part of engines
2.3. Engine cooling system
2.4. Engine lubrication system
2.5. Fuel system
2.6. System of ignition
2.7. System of release
2.8. The engine and system of decrease in toxicity of the fulfilled gases (M13 and M16 engines)
2.8.1. Electronic control system
2.8.2. Service on the car
2.8.3. Control unit of the engine of an electronic control system (electronic control unit)
2.8.4. The sensor of absolute pressure in a collector
2.8.5. Sensor of provision of a butterfly valve
2.8.6. The air temperature sensor on an admission
2.8.7. Sensor of temperature of cooling liquid of the engine
2.8.8. The sensor of concentration of oxygen with heating (the sensor of concentration of oxygen with heating No. 1 and the sensor of concentration of oxygen with heating No. 2)
2.8.9. Check of the sensor of provision of a cam-shaft
2.8.10. Check of the sensor of provision of a bent shaft
2.8.11. Main relay, relay of the fuel pump, relay of the compressor of the air conditioning system and relay of the fan of the condenser of the air conditioning system
2.8.12. Check of a control system of the fan of a radiator
2.8.13. Check of the filter of system of catching of vapors of gasoline of system of decrease in toxicity of the fulfilled gases
2.8.14. Check of the filter of system of catching of vapors of gasoline
2.8.15. System of ventilation of a case
2.9. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 



2-8-7-datchik-temperatury-okhlazhdayushhejj-zhidkosti-dvigatelya.html

2.8.7. Sensor of temperature of cooling liquid of the engine

Removal
Fig. 2.281. Sensor of temperature of cooling liquid of the engine

Disconnect a wire from a negative conclusion of the rechargeable battery (fig. 2.281).
Merge cooling liquid.

ATTENTION
Not to get burns, do not remove a radiator stopper if the engine and a radiator did not cool down yet. If the engine cooled down not enough, then at removal of a stopper of a radiator there can be an emission of hot liquid and steam.

Remove an inlet pipe.
Disconnect the socket from the sensor.
Remove the sensor 1 from the thermostat case.

Check
Ship a sensitive element of the sensor of temperature of the sensor 1 in water (or ice) and measure resistance between sensor conclusions at gradual heating of water.
Fig. 2.282. Check of the sensor of temperature of cooling liquid of the engine

If the measured resistance does not correspond to the characteristic shown in the left figure 2.282, replace the sensor 1.

Installation
Installation is made as it should be, the return to removal, except for the following.
Clear the interfaced surfaces of the sensor 1 and the case of the thermostat.
Check a sealing ring for existence of damages and replace in case of need.
Tighten the sensor of temperature of cooling liquid 1 nominal force of an inhaling.
Moment of an inhaling of the sensor of temperature of cooling liquid (a): 15 N · m.
Connect the socket to the sensor of temperature of cooling liquid 1.
Add cooling liquid.
"previous page
2.8.6. The air temperature sensor on an admission		 following page"
2.8.8. The sensor of concentration of oxygen with heating (the sensor of concentration of oxygen with heating No. 1 and the sensor of concentration of oxygen with heating No. 2)