Suzuki Liana since 2002
1. Operation and maintenance of the car
2. Engine
2.1. Preliminary checks
2.2. Mechanical part of engines
2.3. Engine cooling system
2.4. Engine lubrication system
2.5. Fuel system
2.6. System of ignition
2.7. System of release
2.8. The engine and system of decrease in toxicity of the fulfilled gases (M13 and M16 engines)
2.8.1. Electronic control system
2.8.2. Service on the car
2.8.3. Control unit of the engine of an electronic control system (electronic control unit)
2.8.4. The sensor of absolute pressure in a collector
2.8.5. Sensor of provision of a butterfly valve
2.8.6. The air temperature sensor on an admission
2.8.7. Sensor of temperature of cooling liquid of the engine
2.8.8. The sensor of concentration of oxygen with heating (the sensor of concentration of oxygen with heating No. 1 and the sensor of concentration of oxygen with heating No. 2)
2.8.9. Check of the sensor of provision of a cam-shaft
2.8.10. Check of the sensor of provision of a bent shaft
2.8.11. Main relay, relay of the fuel pump, relay of the compressor of the air conditioning system and relay of the fan of the condenser of the air conditioning system
2.8.12. Check of a control system of the fan of a radiator
2.8.13. Check of the filter of system of catching of vapors of gasoline of system of decrease in toxicity of the fulfilled gases
2.8.14. Check of the filter of system of catching of vapors of gasoline
2.8.15. System of ventilation of a case
2.9. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 






2-8-6-datchik-temperatury-vozdukha-na-vpuske.html

2.8.6. The air temperature sensor on an admission

Removal
Disconnect a wire from a negative conclusion of the rechargeable battery.
Disconnect the socket 1 from the air temperature sensor on an admission.

Fig. 2.279. The air temperature sensor on an admission


Remove the air temperature sensor on an admission from the case of the air filter 2 (fig. 2.279).

Check
Ship a sensitive part of the sensor of air temperature on an admission in water (or put on ice) and measure resistance between sensor conclusions at gradual heating of water.

Fig. 2.280. Check of the sensor of air temperature on an admission


If the measured resistance does not correspond to the characteristic shown in the figure 2.280, replace the air temperature sensor on an admission.

Installation
Installation is made as it should be, the return to removal, except for the following.
Clear the interfaced surfaces of the sensor of air temperature on an admission and cases of the air filter.
Connect the air temperature sensor socket on an admission of 1 (fig. 2.279).

"previous page
2.8.5. Sensor of provision of a butterfly valve
following page"
2.8.7. Sensor of temperature of cooling liquid of the engine