Suzuki Liana since 2002
1. Operation and maintenance of the car
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.3.1. General description
3.3.2. Design of system of blocking of brakes
3.3.3. Check of level of liquid in the automatic transmission
3.3.4. Replacement of liquid in the automatic transmission
3.3.5. Removal and installation of a cable of the choice of transfer
3.3.6. Adjustment of a cable of the choice of transfer
3.3.7. Check and adjustment of the sensor of the mode of the movement (switching sensor)
3.3.8. Removal and installation of the sensor of speed of the leading shaft
3.3.9. Check of the sensor of speed of the leading shaft
3.3.10. Removal and installation of the sensor of temperature of liquid
3.3.11. Check of the sensor of temperature of liquid
3.3.12. Check of the switch of the mode of the raising transfer
3.3.13. Removal and installation of electromagnetic valves (switching valve, valve of the hydrotransformer and valve of synchronization)
3.3.14. Check of electromagnetic valves (switching valves, electromagnetic valve of the hydrotransformer and electromagnetic valve of synchronization)
3.3.15. Replacement of an epiploon from differential
3.3.16. Replacement of the electromagnetic device of blocking of switching
3.3.17. Removal and installation of a cable of blocking of a key
3.3.18. Replacement of hoses of a cooler of the automatic transmission
3.4. Driving mechanism
3.5. Tables
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 










3-3-16-zamena-ehlektromagnitnogo-ustrojjstva-blokirovki-pereklyucheniya.html

3.3.16. Replacement of the electromagnetic device of blocking of switching

Remove facing of the drive of the parking brake system and the console.

Fig. 3.115. Electromagnetic device of blocking of switching


Replace the electromagnetic device of blocking of switching of 1 (fig. 3.115).
Establish facing and a cover into place.

NOTE
Make sure that the fixing pin 3, is blocked in situation "P" by a cam 2 solenoids.
Make sure that the cam 2 solenoids is involved at inclusion of ignition and pressing a brake pedal, providing thus an utaplivaniye of the fixing pin 3.


"previous page
3.3.15. Replacement of an epiploon from differential
following page"
3.3.17. Removal and installation of a cable of blocking of a key