Suzuki Liana since 2002
1. Operation and maintenance of the car
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.3.1. General description
3.3.2. Design of system of blocking of brakes
3.3.3. Check of level of liquid in the automatic transmission
3.3.4. Replacement of liquid in the automatic transmission
3.3.5. Removal and installation of a cable of the choice of transfer
3.3.6. Adjustment of a cable of the choice of transfer
3.3.7. Check and adjustment of the sensor of the mode of the movement (switching sensor)
3.3.8. Removal and installation of the sensor of speed of the leading shaft
3.3.9. Check of the sensor of speed of the leading shaft
3.3.10. Removal and installation of the sensor of temperature of liquid
3.3.11. Check of the sensor of temperature of liquid
3.3.12. Check of the switch of the mode of the raising transfer
3.3.13. Removal and installation of electromagnetic valves (switching valve, valve of the hydrotransformer and valve of synchronization)
3.3.14. Check of electromagnetic valves (switching valves, electromagnetic valve of the hydrotransformer and electromagnetic valve of synchronization)
3.3.15. Replacement of an epiploon from differential
3.3.16. Replacement of the electromagnetic device of blocking of switching
3.3.17. Removal and installation of a cable of blocking of a key
3.3.18. Replacement of hoses of a cooler of the automatic transmission
3.4. Driving mechanism
3.5. Tables
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 










3-3-8-snyatie-i-ustanovka-datchika-skorosti-vedushhego-vala.html

3.3.8. Removal and installation of the sensor of speed of the leading shaft

Removal
Disconnect a wire from a negative conclusion of the rechargeable battery.
Disconnect the socket of the sensor of speed of the leading shaft 2.

Fig. 3.100. Sensor of speed of the leading shaft


Remove the sensor of speed of the leading shaft 1 having turned off a bolt (fig. 3.100).

Installation
Apply liquid for the automatic transmission on a sealing ring of the sensor of speed of the leading shaft.
Install the sensor of speed of the leading shaft 1 in the case of the automatic transmission and tighten a bolt the nominal force of an inhaling.
Moment of an inhaling of a bolt of the sensor of speed of the leading shaft (a): 5,5 Nanometers.
Connect the socket of the sensor of speed of the leading shaft 2 to the sensor of speed of the leading shaft of 1 (fig. 3.100).
Connect a wire to a negative conclusion of the rechargeable battery.

"previous page
3.3.7. Check and adjustment of the sensor of the mode of the movement (switching sensor)
following page"
3.3.9. Check of the sensor of speed of the leading shaft