Suzuki Liana since 2002
1. Operation and maintenance of the car
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.3.1. General description
3.3.2. Design of system of blocking of brakes
3.3.3. Check of level of liquid in the automatic transmission
3.3.4. Replacement of liquid in the automatic transmission
3.3.5. Removal and installation of a cable of the choice of transfer
3.3.6. Adjustment of a cable of the choice of transfer
3.3.7. Check and adjustment of the sensor of the mode of the movement (switching sensor)
3.3.8. Removal and installation of the sensor of speed of the leading shaft
3.3.9. Check of the sensor of speed of the leading shaft
3.3.10. Removal and installation of the sensor of temperature of liquid
3.3.11. Check of the sensor of temperature of liquid
3.3.12. Check of the switch of the mode of the raising transfer
3.3.13. Removal and installation of electromagnetic valves (switching valve, valve of the hydrotransformer and valve of synchronization)
3.3.14. Check of electromagnetic valves (switching valves, electromagnetic valve of the hydrotransformer and electromagnetic valve of synchronization)
3.3.15. Replacement of an epiploon from differential
3.3.16. Replacement of the electromagnetic device of blocking of switching
3.3.17. Removal and installation of a cable of blocking of a key
3.3.18. Replacement of hoses of a cooler of the automatic transmission
3.4. Driving mechanism
3.5. Tables
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 










3-3-5-snyatie-i-ustanovka-trosa-vybora-peredachi.html

3.3.5. Removal and installation of a cable of the choice of transfer

Fig. 3.92. Transfer choice cable details: 1 – selector lever; 2 – transfer choice cable; 3 – holder of a cable of the choice of transfer; 4 – cable arm; 5 – gear shifting lever; 6 – clip; 7 – bolt of the holder of a cable of the choice of transfer; 8 – gear shifting lever pin; 9 – selector lever pin



Removal
Uncover the lever of the drive of the parking brake system.
Remove the console.
Disconnect a cable of the choice of transfer from the selector lever, then disconnect from an arm.
Take out a clip and disconnect a cable of the choice of transfer from the switching lever.
Take out the holder of a cable of the choice of transfer from the dashboard.

Installation
Establish a cable of the choice of transfer to the sequences, the return to removal. At installation pay attention to the following operations.
Apply jellied lubricant on a pin and a tip of a cable.
Tighten bolts the nominal force of an inhaling.
Adjust the drive.

"previous page
3.3.4. Replacement of liquid in the automatic transmission
following page"
3.3.6. Adjustment of a cable of the choice of transfer