2.1.1. Check of a driving belt

ATTENTION Make sure that disconnected a negative wire from the rechargeable battery before check, adjustment and replacement of a belt.

Fig. 2.1. Driving belt of the generator

Check a belt 1 for existence of cracks, cuts, deformations, wear, purity and a tension. If malfunction is found, adjust or replace (fig. 2.1).

Fig. 2.2. Driving compressor belt of the air conditioning system and/or pump of the amplifier of steering: And – the car with steering with the amplifier; In – the car with steering with the amplifier and the conditioner

Check a belt 1 for existence of cracks, cuts, deformations, wear, purity and a tension. If malfunction is found, adjust or replace (fig. 2.2).

Fig. 2.3. Check of gaps in the drive of valves: 1 – cam-shaft; 2 – probe

Check gaps in inlet and final valves and adjust if necessary (fig. 2.3).

ATTENTION Is fresher and the fulfilled engine oil can constitute danger. During start of the engine, be convinced that during its work sufficient ventilation is provided.

Before discharge of engine oil, check the engine for existence of leak of oil. If leak signs are found, replace a defective part before vypolneny the work described below.

Fig. 2.4. Drain stopper

Merge engine oil having turned off a drain stopper (fig. 2.4).

After discharge of oil wipe clean a drain stopper. Establish a drain stopper into place and reliably tighten it, as shown below.

Moment of an inhaling of a drain stopper (a): 50 N · m.