2.1.10. Removal and installation of a high-voltage wire

Uncover the engine a cover of a head of the block of cylinders.

Fig. 2.28. Detachment of high-voltage wires

Disconnect a high-voltage wire of the first cylinder 2 and a high-voltage wire of the third cylinder 3 from blocks of coils of ignition of 1 (fig. 2.28).

Remove high-voltage wires from spark plugs.

ATTENTION It is recommended to remove high-voltage wires together with tips not to damage an internal wire (a resistive wire). For the same reason, separate all connections holding a wire for a tip.

Connect a high-voltage wire of the first cylinder 2 and a high-voltage wire of the third cylinder 3 to spark plugs and blocks of coils of ignition of 1 (fig. 2.28).

Establish an engine cover on a cover of a head of the block of cylinders.

ATTENTION Never use when replacing high-voltage wires of a wire with the metal conductor. At connection of high-voltage wires you watch that the tip of a wire was put on completely.