Suzuki Liana since 2002
1. Operation and maintenance of the car
2. Engine
2.1. Preliminary checks
2.1.1. Check of a driving belt
2.1.2. Replacement of an oil filter
2.1.3. Check of a compression
2.1.4. Engine vacuum check
2.1.5. Check of gaps in the drive of valves
2.1.6. Check of level of cooling liquid
2.1.7. Check and cleaning of the cooling system of the engine
2.1.8. Check of the mode of a cut-off of supply of fuel
2.1.9. Check of a spark of ignition
2.1.10. Removal and installation of a high-voltage wire
2.1.11. Check of a high-voltage wire
2.1.12. Removal and installation of a spark plug
2.1.13. Check of a spark plug
2.1.14. Removal and installation of the coil of ignition (with igniter)
2.1.15. Check of the coil of ignition (with igniter)
2.1.16. Check of installation of a corner of an advancing of ignition
2.2. Mechanical part of engines
2.3. Engine cooling system
2.4. Engine lubrication system
2.5. Fuel system
2.6. System of ignition
2.7. System of release
2.8. The engine and system of decrease in toxicity of the fulfilled gases (M13 and M16 engines)
2.9. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 










2-1-6-proverka-urovnya-okhlazhdayushhejj-zhidkosti.html

2.1.6. Check of level of cooling liquid

To check the level of cooling liquid, lift a cowl and check level in a broad tank of the cooling system (the tank is made of transparent plastic).

NOTE
For check of level of cooling liquid it is not required to remove a radiator stopper.

ATTENTION
Not to get burns do not uncover a tank if cooling liquid boils.
Do not remove a radiator stopper if the engine and a radiator did not cool down yet.

Fig. 2.24. Cooling system components


If the engine cooled down not enough, then at removal of a stopper of a radiator there can be an emission of hot liquid and couple (fig. 2.24).

When the engine cools down, check the level of cooling liquid in a broad tank 1.
Level of cooling liquid is normal if it is between a tag of FULL 2 and LOW 3 on a broad tank 1.
If the level of cooling liquid – is lower than LOW 3 tag, uncover a broad tank 4 and add cooling liquid in the tank to FULL 2 tag. Then establish a cover 4 and combine tags 5 on the tank and a cover.

NOTE
If suitable qualitative antifreeze is used, there is no need to add additional inhibitors or additives which, allegedly, improve work of system. They can make negative impact on functioning of system and enter into unnecessary expenses.
At installation of a cover of a tank combine tags in the form of arrows on the tank and a cover.


"previous page
2.1.5. Check of gaps in the drive of valves
following page"
2.1.7. Check and cleaning of the cooling system of the engine