Suzuki Liana since 2002
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General description
6.1.1. Design of the brake system
6.1.2. Check of pressure (if there is LSPV pressure limiter)
6.1.3. Check of height of a pedal of a brake
6.1.4. Removal of air from the brake system
6.1.5. Removal and installation of the hose / pipeline of the forward brake mechanism
6.1.6. Removal and ustanovkashlang / pipeline of the back brake mechanism
6.1.7. Check of brake hoses and pipelines
6.1.8. Removal and installation of the tank of the main cylinder
6.1.9. Removal and installation of the main cylinder
6.1.10. Dismantling and assembly of the main cylinder
6.1.11. Assembly of the main cylinder
6.1.12. Check of the main cylinder
6.1.13. Amplifier of brakes
6.1.14. Removal and installation of the amplifier of brakes
6.1.15. Check and adjustment of the amplifier of brakes
6.1.16. Removal and installation of the limiter of pressure depending on loading
6.1.17. Check and adjustment of the parking brake system
6.1.18. Removal and installation of a cable of the parking brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 






6-1-10-razborka-i-sborka-glavnogo-cilindra.html

6.1.10. Dismantling and assembly of the main cylinder

Dismantling of the main cylinder

Fig. 6.20. Piston limiter bolt


For cars with the left arrangement of steering without anti-blocking system of brakes – turn off a bolt of the limiter of the piston 1 (fig. 6.20).

Fig. 6.21. Utaplivaniye of the piston of primary camera


For cars with the left arrangement of steering with anti-blocking system of brakes – drown the piston of primary camera 1 to remove a pin of the limiter of the piston of the secondary camera 2 of the main cylinder, as shown in the figure 6.21.
Remove a lock ring 1.

Fig. 6.22. Removal of a lock ring and extraction of the piston of the secondary camera


Take out the piston of primary camera. Take out the piston of the secondary camera by means of compressed air 2. Be careful as the secondary piston can jump out of the cylinder (fig. 6.22).

ATTENTION
Do not use compressed air of excessive pressure, it will lead to a piston departure from the cylinder. Close an exhaust outlet fabric to prevent damage of the piston. Pressure of air has to be moderate. Protect fingers at extraction of the piston by means of compressed air.

"previous page
6.1.9. Removal and installation of the main cylinder
following page"
6.1.11. Assembly of the main cylinder