|
5-2-2-snyatie-i-ustanovka-kontaktnojj-spirali-i-kombinirovannogo-pereklyuchatelya.html
5.2.2. Removal and installation of a contact spiral and the combined switch
|
ATTENTION
Do not turn a contact spiral (on the combined switch) more than on two and a quarter turns from the central situation on or counterclockwise, otherwise, the spiral will break.
|
Removal
Remove a steering wheel, see. "Removal and installation of a steering wheel".
Remove the lower panel of a steering column 1 (fig. 5.11).
|
|
Fig. 5.12. Screws of fastening of the top and lower covers of a steering column
|
Unscrew screws of a cover of a steering column 1 (fig. 5.12). Separate the top cover 2 from the lower cover 3, then remove their (fig. 5.12).
|
|
Fig. 5.13. Screws of fastening of the combined switch
|
Remove a contact spiral and unscrew screws of the combined switch 1, disconnect sockets 2 from the combined switch 3 (fig. 5.13).
Disconnect the socket of a sound signal and the socket of an inflatable safety cushion 1 from a plait of the dashboard (fig. 5.14). Remove a contact spiral and the combined switch from a steering column.
Installation
Make sure that forward wheels of the car are established in provision of the rectilinear movement, then install the ignition switch in the provision of "LOCK".
|
|
Fig. 5.15. Installation of the combined switch
|
Establish a contact spiral and the combined switch 3, then connect all sockets disconnected at removal (fig. 5.15).
|
NOTE
The new contact spiral assembled with the combined switch is delivered in spare parts established in the central situation with the blocking pin 1 and consolidation 2. Remove the blocking pin after installation of a contact spiral and the combined switch on a steering column (fig. 5.15).
|
|
|
Fig. 5.16. Installation of the top and lower covers of a steering column
|
Establish the top facing steering columns 2 and the lower cover 3, then tighten screws of a cover of a steering column 1 (fig. 5.16).
|
ATTENTION
At installation of the lower facing 3 and the top facing 2 you watch that wires of a contact spiral and the combined switch did not get between covers (fig. 5.16).
|
Install the lower panel of a steering column 1 (fig. 5.11). Establish a steering wheel on a steering shaft.
|