Suzuki Liana since 2002
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
5.1. Diagnostics of malfunctions of steering
5.2. Steering repair
5.2.1. Removal and installation of a steering wheel
5.2.2. Removal and installation of a contact spiral and the combined switch
5.2.3. Centering of a contact spiral
5.2.4. Removal and installation of a steering column
5.2.5. Removal and installation of the switch of ignition with the anti-theft device
5.2.6. Removal and installation of the lower shaft of steering
5.2.7. Steering with the amplifier
5.2.8. Check of a free wheeling of a steering wheel
5.2.9. Check of effort on a steering wheel
5.2.10. Check of work of system of stabilization of idling
5.2.11. Check of pressure in a hydraulic system of the amplifier of steering
5.2.12. Check of level of liquid
5.2.13. Procedure of removal of air
5.2.14. Check of a driving belt of the pump of the hydraulic booster of steering on the car
5.2.15. Adjustment of a tension of a driving belt of the pump of the hydraulic booster of steering
5.2.16. Removal and installation of a driving belt of the pump of the hydraulic booster of steering
5.2.17. Removal and installation of a steering rod end of draft
5.2.18. Steering mechanism
5.2.19. Removal and installation of the steering mechanism
5.2.20. Removal and installation of a cover of a draft / lath
5.2.21. Removal and installation of the pump of the hydraulic booster of steering
5.2.22. Dismantling and assembly of the pump of the hydraulic booster of steering
5.2.23. Check of the pump of the hydraulic booster of steering
5.3. Tables
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 










5-2-21-snyatie-i-ustanovka-nasosa-gidrousilitelya-rulevogo-upravleniya.html

5.2.21. Removal and installation of the pump of the hydraulic booster of steering

Fig. 5.68. Details of the pump of the hydraulic booster of steering: A – an adjusting tag for the acting part of a broad tank; B – tighten a bolt with the limiter; 1 – the steering pump with the amplifier; 2 – a steering tank with the amplifier; 3 – pressure head hoses and tube; 4 – the soaking-up hose; 5 – a returnable hose of low pressure (from a tank); 6 – returnable tube of low pressure; 7 – returnable hose of low pressure and tube; 8 – arm; 9 – belt tension pulley; 10 – belt tension pulley bolt; 11 – belt tension pulley nut; 12 – belt of the drive of the pump of the hydraulic booster



NOTE
Make sure that carefully cleared each connection before dismantling.

Removal
Remove the lower cover of the engine on the right side, weaken a pulley of the tension device of a belt and take off a belt of the drive of the amplifier of steering.
Disconnect the pressure head pipeline of high pressure and the soaking-up hose from the pump. Collect the following liquid in a container or muffle tubes.

ATTENTION
You watch to damaging the condenser of the air conditioning system (if is available).

Disconnect a plait of the sensor of pressure and a plait of wires of the air conditioning system.
Remove the compressor of the air conditioning system from an arm without disconnecting a hose of the air conditioning system.

NOTE
Suspend the compressor of the air conditioning system on a wire hook so that hoses of the air conditioning system were not bent, excessively overwound or tense.

Remove the oil pump from an arm.

NOTE
Muffle channels of the pump to prevent hit of dust and foreign objects in the pump.

Installation
Installation is made as it should be, the return to removal.

NOTE
After installation fill with liquid a tank of the hydraulic booster of steering and remove air from system.

The moments of an inhaling are given in the section "Details of the Pump of the Hydraulic Booster of Steering".
Adjust a tension of a belt of the hydraulic booster of steering, see. "Adjustment of a tension of a driving belt of the pump of the hydraulic booster of steering".
Remove air from system.

"previous page
5.2.20. Removal and installation of a cover of a draft / lath
following page"
5.2.22. Dismantling and assembly of the pump of the hydraulic booster of steering